Mechanical — Plumbing, HVAC & Electrical

Heating & Cooling (HVAC) in Metro Detroit

A furnace that fails in a Michigan January is not an inconvenience, it is an emergency. We match Metro Detroit homeowners with licensed, insured HVAC pros who size the system correctly, install it to code, and pull the permit — so it keeps your house warm for years.

Typical range: $4000–$9000 per system

  • Licensed & insured local pros
  • Permit-ready for mechanical — plumbing, hvac & electrical work
  • Free, no-obligation quotes

Free Quote — 60 Seconds

Tell us about your project and we’ll match you with a vetted, licensed local pro. No obligation.

🔒 Always free for homeowners · No obligation · We never share your info

A heating and cooling system is the most expensive mechanical purchase most homeowners make, and the install matters as much as the equipment. An oversized furnace short-cycles and wears out early; an undersized one never keeps up on the coldest nights. Ductwork, gas line, venting, and the load calculation all have to be right, and in Michigan getting heating right is not optional — it is the difference between a comfortable winter and a frozen pipe. The HVAC pros in our network handle furnace and AC replacement, heat pump installs, new system design, and the permit and inspection that prove it was done to code.

Older Metro Detroit homes complicate the job: a Berkley bungalow with one return and undersized ducts, or a Huntington Woods two-story where the upstairs bakes in summer and freezes in winter. Sizing equipment to a real load calculation — not a rule of thumb or whatever was there before — is what separates a comfortable home from one with an expensive box that never quite works. We match you with a licensed pro who does that math.

What’s included

  • In-home assessment and Manual J load calculation
  • Permit pulled and inspection scheduled with your municipality
  • Furnace, AC, or heat pump sized to your home — not a guess
  • Ductwork, gas line, and venting evaluation and corrections
  • Proper line-set, condensate, and electrical hookup
  • Old-equipment removal and refrigerant handled per regulation
  • System startup, airflow check, and walkthrough of the controls

Gas and refrigerant leave no room for amateurs — a bad install can mean carbon monoxide, a code-flunking gas line, or a system that dies young. Every HVAC pro we match you with is state-licensed, insured, and pulls the permit, so your install is sized right and inspected, not just sold.

How it works

Assess & size

A licensed pro measures the home and runs a load calculation so the equipment is sized to how your house actually loses and gains heat.

Permit & specify

The right efficiency and capacity are specified, the permit is pulled, and ductwork or gas-line corrections are identified before install.

Remove the old system

The failing unit is disconnected, refrigerant is recovered per EPA rules, and the old equipment is hauled away.

Install to code

New equipment is set, ducted, vented, and wired to code, with the line-set, condensate, and gas connections done correctly.

Start up & inspect

The system is commissioned and airflow verified, then the municipal inspector signs off — confirmation the install meets code.

Heating & Cooling (HVAC) by city

We match hvac projects with vetted pros across Metro Detroit.

Heating & Cooling (HVAC): common questions

Should I repair my furnace or replace it?
A young furnace with a cheap part failure is worth repairing. But once a unit is 15–20 years old, needs an expensive repair, or has a cracked heat exchanger, replacement usually wins — a new high-efficiency furnace cuts gas bills and ends the breakdown risk. The licensed pros we match you with give you the honest math, not a reflex upsell.
How do I know what size furnace I need?
A proper load calculation, not a rule of thumb. The right size depends on your square footage, insulation, windows, and layout. Bigger is not better — an oversized furnace short-cycles, wears out faster, and heats unevenly. A licensed HVAC pro runs the math so the equipment matches your actual home.
Will the installation be permitted and inspected?
Yes. Furnace and AC replacements in Michigan require a permit and inspection because gas, venting, and electrical are involved. That inspection protects you and your home, and the licensed pros we route treat it as standard — not a corner to cut.
Is a heat pump a good idea in Michigan winters?
Modern cold-climate heat pumps perform far better in low temperatures than older ones, and many Michigan homes now run a heat pump with a gas furnace as backup for the coldest stretches. Whether it fits depends on your home and ductwork, which is exactly what a licensed pro evaluates before recommending it.

Get matched with a hvac pro

Get matched with a vetted, licensed Metro Detroit pro today. Free quotes, no obligation.